2 The inner edges of the mat will be equal to or slightly smaller than the image to be framed. The resulting measurement will be the length and width of the outer edges of the mat. I found that if I scraped for a bit, then performed the same motion on the reverse side of the blade on top of sandpaper, that I could easily sharpen it and get consistent results. Double the mat width you have decided on and add this to the picture length and width. There are videos on youtube and chapters of books devoted to caring for and maintaining scrapers, not being a professional, I ignored them all. It worked wonderfully, you just make short, repetitive scraping motions towards you, and watch the grain completely flatten out and become almost glass smooth. Once I was finished sanding them, I used an old paint scraper as a cheapo cabinet scraper. I was careful to always keep it flat and level and just took my time. I was a bit worried that using the rough paper would create valleys and dips in the wood, but seeing as it was so dense the machine could really only take off the very outer layer unless I held it in place for a while. Using 80grit paper I ran each length over the belt until I was left with a flat surface. I decided to use my larger belt sander for this task. I needed to smooth the lengths out, remove the burn marks and get them as flat as possible. In this case, the rabbets are where the glass and picture sit in the frame without falling through the front. Now I don't have a thicknesser, jointer or even a decent handplane so my options were limited for this step. A rabbet is a small channel cut along the edge of a piece of wood.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |